How To install Rove R2-4k Dash Cam?
Before installing R2-4k, please check if R2-4k Dash Cam can work properly, make sure it can work properly before you install R2-4k in your car.
The device will start up Automatically and record as soon as power supplied, and the device will save the last video file and power off automatically after cutting the power supply.
Be sure to insert the Memory card before powering up the device. Do NOT insert/remove the memory card while the camera is turned ON. Only do so when it is turned OFF.
install Rove R2-4k
1. Most people will install their R2-4K next to the rear view mirror and opposite side form the drive. First, Stop the engine where there is some light and in a safe place, and then remove the key.
2. Make sure to clean your windshield from the dust particles and an evaporated grease from the dashboard surface.
3. Attach the ROVE R2-4K with the suction mount. Set the camera lens to pointing forward to the center when installing it.
4. To Lock The Suction Mount: Press & hold it tight towards windshield to remove any air between suction mount and the windshield. While pressing & holding towards the windshield, turn the LOCKING Knob towards CLOCKWISE to LOCK in place.
5. Use the power cord to connect the USB Port of the product to car’s cigarette lighter socket.
Recommend use ROVE’s USB Car Charger, otherwise the camera may frequently reboot or flicker LCD due to insufficient power.
6. Use the cable clip to organize and hide the power cord so that it doesn’t interfere with the driver’s vision.
7. Adjust the lens angle of the camera.
Loosen the screw to adjust the camera’s view angle and then tighten to lock that angle.
Simply rotate the camera 360o to record any direction you prefer.
7. Start the engine and check if the product works properly.
Installation Notes
Make sure that the camera’s view is not obstructed by any window tint or any other objects.
If your vehicle has side curtain airbags please be very careful when running any cables along your vehicle windows. Ensure you are
not running Cable past any of the airbags as this can prevent the airbags from deploying.
Make sure to remove the Plastic Lens Screen Protector from the lens before recording videos. Otherwise your videos will look blurry and blocked.
Do not remove the Micro-SD card while the camera is turned ON.
Otherwise it may cause memory card to be write protected and possible loss of data or damage your memory card. Always remove/insert memory card while camera is turned OFF
https://cardashcamtech.com/